ðëúá áî÷åø òì éãé
eransh
àåìé áúéàåøéä æä öéèåè îúåê Glpro:
Setup
You need to setup this module after installation. Perform the setup only when the
engine is WARM so the idle speed is normal.
- Find a long, straight road with light traffic. The unit does not learn the same
gear twice, this makes it easy to set up on the road. You can even shift down
and stop during the setup if needed. Do not steer the display, watch the road
and ride with extreme care as always!
- Turn the ignition On. The display counts backwards (6 to 1) indicating
that the memory is clear.
- When “L” is flashing, start the engine in Neutral and let the engine idle.
- When the display is flashing “1”, select first gear, release the clutch and
start riding normally.
The display is blinking faster while the unit is learning the gear.
- When the display shows “n” (next), select second gear.
Repeat this process until all gears are thought.
In top gear, wait until “o” (over) is indicated and the display stops
blinking.
The unit is now programmed and should indicate all gears correctly.
When ignition is turned on, the display counts forward (1 to 6) indicating that it
is programmed and fully functional.
éëåì ìäéåú ùäí ôùåè îééöøéí îùäå ëììé ùîúàéí ìøåá äàåôðåòéí, ìëï öøéê ìäëðéñ àú éçñ äòáøä (áàîöòåú ùéìåá ääéìåê) éãðéú.