.
1 & 3.
:
1- + #1 - #2 - #4 -> .
2- -> .
?
?
P 360 CKP RESISTANCE INSPECTION.JPG
. - 2 - 4. 1 - 3 .
CDI .
?
cdi coil .
Sent from my iPhone using Tapatalk
https://www.gixxer.com/threads/fault...-coils.240426/
Hi guys, I have a bit of an update on my situation.
I found a method for testing my ignition, which involves attaching a 12 volt lamp between the negative side of my coil and the ground wire. When the engine is cranked this light should flash on and off as the CDI grounds and ungrounds the coil, so as to induce spark.
I tried this out and got a flashing light on my "good" side, but the light just remained on when attached to the coil on my "bad" side. This means either the CDI is not working properly, or that it is not getting the correct signal from the pickup coils.
Before i splashed out on a replacement CDI I checked the resistance on my pickup coil windings (this is something i didnt know how to do earlier). I have about 290 ohms on one of the windings and 2050 ohms on the other. I believe spec is round 300ohms so it looks like my problem is my pickup coils after all.
Sent from my iPhone using Tapatalk
.
- cdi . 1 - 3 - 2 -4.
- - ' - - .
.
- . ( ).
- - cdi .
- .
- "stva" . ?
- .
- - .
?
12
? ?
.
https://youtu.be/rRQ45lT2d3c
https://youtu.be/Ljvq7t6Nkn0
https://youtu.be/UXGwR4Gf964
Sent from my iPhone using Tapatalk
Hi, Moboyd91 and the usual suspects are:
1. Fouled spark plugs.
2. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Loose connection at ignition coil or plug between ignition sensor and module.
5. Spark plug cables in bad condition, shorting/leaking, spark plug cable connections loose check for spark leakage in the dark.
6. Faulty ignition coil or electronic control module.
7. Faulty pulse coil.
8. Faulty CKP, CMP, or BAS sensor.
9. Faulty ignition switch.
10. Faulty run/off switch
11. Tilt sensor needs a reset.
12. Security alarm failing to disarm needs reset
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.gixxer.com/forums/17-sra...park-help.html
How to diagnose no spark situation on motorcycle
Suzuki GSX R750 Service Manual
https://www.partsfish.com/page/oem-parts-for-suzuki
http://mybikemanuals.com/suzuki
Sent from my iPhone using Tapatalk
[QUOTE=Tilbalisti;164633]
? ?
.... ?
Sent from my Redmi 6 using Tapatalk