ימאהה WR250R WR250X מדריך טיפולים שיפורים תוספות מיגונים

[SM26]

בפוסט הקודם דיברתי על מצב CO, ובסוף גם נגיעה לגבי מצב דיאגנוסטיקה

טיפה בהרחבה,
אנחנו יכולים לבצע כל מיני בדיקות מאוד נחמדות בעזרת המחשב המקורי של האופנוע
לדוגמא, איך לבדוק שהמאוורר עובד ב90 שניות או פחות


מצ"ב הסבר באנגלית על כל הקודים:

Diagnostics Mode
The WR has a fantastic little diagnostics mode built right in to the cluster. Below are the steps to enter the diagnostics mode, and an explanation of what each of the options.

How to Enter Diagnostics Mode
Ensure the killswitch is set to OFF
Press and hold the ‘RESET’ and ‘SELECT1’ buttons
Turn on the ignition key
Hold both buttons for 8 seconds until display changes to ‘Diag’
Press both buttons again and hold for another 3 seconds until display changes to ‘D01’
Cycle though the menu using ‘SELECT1’ and ‘SELECT2’
Note: For options 30-53 set kill switch to run then back to off to actuate diagnostics.

01 Throttle Angle: Fully closed position 15-19, Fully opened position 95–100
03 Pressure Difference: Displays the intake air pressure (Atmospheric Pressure minus Intake Pressure)
05 Intake Air Temperature: Displays the intake air temperature
06 Coolant Temperature: Displays the coolant temperature
07 Vehicle Speed Pulse: 0–999
08 Lean Angle Sensor: Upright 0.4–1.4v, Overturned 3.7–4.4v
09 Fuel System Voltage: Approximately 12.0v
20 Sidestand Switch: Stand up ON, Stand down OFF (with the transmission in gear)
21 Neutral Switch: Neutral ON, In gear OFF
23 O2 Sensor problem
30 Ignition Coil: Actuates the ignition coil once every second 5 times
36 Injector: Actuates the injector once every second 5 times
48 Air Induction Solenoid (AIS): Actuates the air inducton system solenoid once every second 5 times
49 Intake Solenoid: Actuates the intake solenoid with the engine running once every second 5 times
50 Fuel Injection System Relay: Actuates the fuel injection system relay once every second 5 times
51 Radiator Fan Motor Relay: Actuates the radiator fan motor relay once every second 5 times
52 Headlight Relay: Actuates the headlight relay once every five-seconds 5 times
53 EXUP Servo Motor: Turn the servo motor once in the open direction and then in the close direction
60 EEPROM Fault Code Display: No fault 00, History exists 04
61 Malfunction History Code Display: No history 00, History exists cycles through the list of stored errors
62 Malfunction History Code Erasure: No history 00, History exists shows number of stored errors
63 Repeated Display of Trouble Code: No malfunction code 0, Malfunction code exists 24
70 Left idle control - After 20 minuts left idiling, the ECU automaticly stops the engine.

fault110.jpg
fault210.jpg